Huaview Technology co., limited
Email: jorwin@huaview.cn TEL: 86--15986697800
Home
Home
>
Cases
>
Huaview Technology co., limited latest company case about 65° Tungsten Steel Radius End Mill Machining Case
EVENTS
LEAVE A MESSAGE

65° Tungsten Steel Radius End Mill Machining Case

2026-11-06

latest company case about 65° Tungsten Steel Radius End Mill Machining Case
65° tungsten carbide radius end mills are mainly used for machining hardened steel, mold steel, alloy steel and other high-hardness materials with HRC 65 or below. They are suitable for high-speed roughing through finishing, and deliver particularly high efficiency when machining mold cavities, curved surfaces and steep surfaces.
🔧 Typical Machining Cases
  1. Mold Cavity Machining (Mastercam Case): A Φ25R5 indexable insert radius end mill is used for curved roughing and pocket roughing on the parting surface of the rear mold, with a machining allowance of 0.3 mm. Then a Φ16R0.8 radius end mill is adopted for contour semi-finishing with a constant Z-height (allowance of 0.15 mm), followed by finishing to 0.0 mm.
  2. Housing Part Machining: A Φ25R5 radius end mill is first used for roughing the upper curved surface of the rear mold cavity platform. Then 2D contour toolpaths are applied for roughing and finishing of the fillet profile, leaving a 0.1 mm Z-axis allowance to avoid collision with the worktable.
  3. Steep Surface Machining: When the slope is greater than 5 degrees, radius end mills or ball nose end mills are recommended instead of flat end mills, because the tool tip is prone to wear and causes inaccurate dimensional precision.
⚙️ Recommended Process Parameters

Roughing Stepover: Set the XY stepover to 55%~85% of the effective cutter diameter

Finishing Stepover: Set the XY stepover to 40%~45% of the effective cutter diameter

Tool Selection: Use radius end mills or high-feed milling cutters for roughing; ball nose end mills for finishing; ball nose end mills, flat end mills or radius end mills for corner cleaning

Radius Matching: Select the R value of the radius end mill according to the Z-direction radius and XY-direction radius of the mold, and take the Z-axis depth of cut, spindle load and chip evacuation capacity into consideration.
⚠️ Notes

The 65° radius end mill is suitable for heat-treated steel below HRC 65. It can be used continuously from roughing to finishing to reduce tool change times.

Radius end mills have cutting edge blind zones. A "top-edge interference" issue may occur in recessed areas, requiring secondary roughing for supplementary machining.

When machining high-hardness materials, tools with TiSiN or AlTiCrN coating are recommended for better heat resistance and anti-adhesion performance.

Contact Us at Any Time

86--15986697800
No160 DongHua Road Xinchang industrial zone Hangli town Dongguan City Guangdong province China 523460
Send your inquiry directly to us