This 55 HRC solid carbide roughing end mill uses a wave edge (corn cob) flute for fast stock removal in steel, copper, brass and aluminum. The wave edge breaks the chip into short segments, so the cutter runs with a much lower radial force than a full flute end mill of the same diameter: the part deflects less, the machine needs less power, and the tool can take a deeper axial cut. Extended flute and overall length versions reach into deep pockets where a standard length rougher cannot go. AlTiN coating protects the edge from the heat generated by high material removal, and the carbide body keeps the wave profile sharp after repeated regrinding.
![]()
Example: RE55 - D10 x 25 x 75 - 4F - AlTiN
| Model | Cutting Dia. | Flute Length | Shank Dia. | Overall Length | Flutes | Coating |
|---|---|---|---|---|---|---|
| RE55-D4 | 4.0 mm | 11 mm | 4.0 mm | 50 mm | 4 | AlTiN |
| RE55-D6 | 6.0 mm | 16 mm | 6.0 mm | 50 mm | 4 | AlTiN |
| RE55-D8 | 8.0 mm | 20 mm | 8.0 mm | 60 mm | 4 | AlTiN |
| RE55-D10 | 10.0 mm | 25 mm | 10.0 mm | 75 mm | 4 | AlTiN |
| RE55-D12 | 12.0 mm | 30 mm | 12.0 mm | 75 mm | 4 | AlTiN |
| RE55-D16 | 16.0 mm | 40 mm | 16.0 mm | 100 mm | 4 | AlTiN |
Extended length and long flute versions for deep pockets are produced to order. Regrinding service keeps the wave profile within tolerance.
| Workpiece / Operation | Recommended Series | Selection Reason |
|---|---|---|
| Hardened steel 45-65 HRC, finishing | 65 HRC Coated Series | Ultra fine grain carbide with AlTiN, holds the edge at high temperature |
| General steel and alloy steel milling | 60 HRC 4 Flute Square Mill | Balanced flute geometry for roughing and finishing in one tool |
| Stainless steel and soft sticky material | 66 HRC 4 Flute Series | Sharp positive rake and polished flute limits work hardening |
| 3D profile, curved surface, mold cavity | 2 Flute Ball Nose Mill | Ball radius generates the surface without scallop marks |
| Roughing with high removal rate | Wave Edge Roughing Mill | Wave edge segments the chip, lower radial force, less chatter |
| Corner radius, bull nose profile, R angle | 4 Flute Corner Radius Mill | R corner strengthens the edge and leaves a controlled fillet |
| Micro features 0.2-0.8 mm | Micro End Mill Series | Sub-micron carbide, 3 mm shank, high rigidity at small diameter |
| Aluminum and copper alloy, mirror finish | 3 Flute U Groove Aluminum Mill | Polished U groove and high helix evacuate soft chips |
![]()
![]()
![]()
Contact Us at Any Time