This 65 HRC solid carbide roughing end mill combines a wave edge flute with a substrate and coating intended for stainless steel. Stainless steel resists stock removal in two ways: it work hardens under a sliding edge and it holds heat at the cutting zone. The wave edge keeps the chip short so the material is cut rather than pushed, and the AlCrN coating keeps the edge hard at the temperature generated by heavy roughing. Four flutes provide the stability needed for deep axial cuts, and the full carbide body limits deflection when the tool is roughing a deep pocket in 304 or duplex stainless steel.
![]()
![]()
![]()
Example: RS65 - D10 x 25 x 75 - 4F - AlCrN
| Model | Cutting Dia. | Flute Length | Shank Dia. | Overall Length | Flutes | Coating |
|---|---|---|---|---|---|---|
| RS65-D4 | 4.0 mm | 11 mm | 4.0 mm | 50 mm | 4 | AlCrN |
| RS65-D6 | 6.0 mm | 16 mm | 6.0 mm | 50 mm | 4 | AlCrN |
| RS65-D8 | 8.0 mm | 20 mm | 8.0 mm | 60 mm | 4 | AlCrN |
| RS65-D10 | 10.0 mm | 25 mm | 10.0 mm | 75 mm | 4 | AlCrN |
| RS65-D12 | 12.0 mm | 30 mm | 12.0 mm | 75 mm | 4 | AlCrN |
| RS65-D16 | 16.0 mm | 40 mm | 16.0 mm | 100 mm | 4 | AlCrN |
Long flute and long reach versions for deep pockets are available. Regrinding keeps the wave profile and coating is renewed on request.
| Workpiece / Operation | Recommended Series | Selection Reason |
|---|---|---|
| Hardened steel 45-65 HRC, finishing | 65 HRC Coated Series | Ultra fine grain carbide with AlTiN, holds the edge at high temperature |
| General steel and alloy steel milling | 60 HRC 4 Flute Square Mill | Balanced flute geometry for roughing and finishing in one tool |
| Stainless steel and soft sticky material | 66 HRC 4 Flute Series | Sharp positive rake and polished flute limits work hardening |
| 3D profile, curved surface, mold cavity | 2 Flute Ball Nose Mill | Ball radius generates the surface without scallop marks |
| Roughing with high removal rate | Wave Edge Roughing Mill | Wave edge segments the chip, lower radial force, less chatter |
| Corner radius, bull nose profile, R angle | 4 Flute Corner Radius Mill | R corner strengthens the edge and leaves a controlled fillet |
| Micro features 0.2-0.8 mm | Micro End Mill Series | Sub-micron carbide, 3 mm shank, high rigidity at small diameter |
| Aluminum and copper alloy, mirror finish | 3 Flute U Groove Aluminum Mill | Polished U groove and high helix evacuate soft chips |
![]()
![]()
Brand: Huaview | MOQ: 5 pieces | Stock delivery: 3-5 working days | OEM/ODM available (laser marking, custom coating, special diameter, flute length and radius). Send your workpiece material, hardness and profile drawing, and we confirm the correct model within 24 hours.
Contact Us at Any Time