This micro end mill is optimized for aluminum and copper rather than for steel: 2 flutes, 45 degree high helix and a polished flute surface. Soft material welds to a rough flute, and once a built up edge forms on a 0.4 mm cutter the tool breaks within minutes. The polished flute and sharp uncoated edge let the chip slide out of the micro slot, and the high helix lifts the chip away from the cut. The 0.2 um grain carbide tip keeps the sharpness needed at this diameter, while the full diameter shank provides the rigidity. Flat tools cut slots and keyways, ball nose tools generate 3D micro surfaces and radius details.
![]()
![]()
Example: AL60 - D0.5 x 1.5 x 50 - 2F - Ball - Polished
| Model | Cutting Dia. | Tip Type | Flute Length | Shank Dia. | Overall Length | Flutes |
|---|---|---|---|---|---|---|
| AL60-D0.2 | 0.2 mm | Flat / Ball | 0.6 mm | 3.175 mm | 50 mm | 2 |
| AL60-D0.3 | 0.3 mm | Flat / Ball | 0.9 mm | 3.175 mm | 50 mm | 2 |
| AL60-D0.4 | 0.4 mm | Flat / Ball | 1.2 mm | 3.175 mm | 50 mm | 2 |
| AL60-D0.5 | 0.5 mm | Flat / Ball | 1.5 mm | 3.175 mm | 50 mm | 2 |
| AL60-D0.6 | 0.6 mm | Flat / Ball | 1.8 mm | 3.175 mm | 50 mm | 2 |
| AL60-D0.8 | 0.8 mm | Flat / Ball | 2.4 mm | 4.0 mm | 50 mm | 2 |
Uncoated polished is standard for aluminum. ZrN coating is available for abrasive aluminum alloys with high silicon content.
| Workpiece / Operation | Recommended Series | Selection Reason |
|---|---|---|
| Hardened steel 45-65 HRC, finishing | 65 HRC Coated Series | Ultra fine grain carbide with AlTiN, holds the edge at high temperature |
| General steel and alloy steel milling | 60 HRC 4 Flute Square Mill | Balanced flute geometry for roughing and finishing in one tool |
| Stainless steel and soft sticky material | 66 HRC 4 Flute Series | Sharp positive rake and polished flute limits work hardening |
| 3D profile, curved surface, mold cavity | 2 Flute Ball Nose Mill | Ball radius generates the surface without scallop marks |
| Roughing with high removal rate | Wave Edge Roughing Mill | Wave edge segments the chip, lower radial force, less chatter |
| Corner radius, bull nose profile, R angle | 4 Flute Corner Radius Mill | R corner strengthens the edge and leaves a controlled fillet |
| Micro features 0.2-0.8 mm | Micro End Mill Series | Sub-micron carbide, 3 mm shank, high rigidity at small diameter |
| Aluminum and copper alloy, mirror finish | 3 Flute U Groove Aluminum Mill | Polished U groove and high helix evacuate soft chips |
![]()
![]()
![]()
Contact Us at Any Time