This 65 HRC solid carbide corner radius end mill is a 4 flute bull nose cutter for R angle milling and fillet profiling in hardened steel. The corner radius distributes the cutting load along an arc instead of concentrating it at a sharp corner, so the tool survives the interrupted cuts and hard spots that break a square end mill at HRC 60 and above. Four flutes give the feed rate and surface quality needed for finishing a shoulder in one pass. Radius sizes R0.5 to R3.0 match the fillet callouts on mold, die and fixture drawings, and the AlTiN coating holds the edge at the temperature generated by high speed finishing.
![]()
![]()
Example: CR65 - D8 x R1.0 x 60 - 4F - AlTiN
| Model | Cutting Dia. | Corner Radius | Flute Length | Shank Dia. | Overall Length | Flutes |
|---|---|---|---|---|---|---|
| CR65-D4-R0.5 | 4.0 mm | R0.5 | 12 mm | 4.0 mm | 50 mm | 4 |
| CR65-D6-R0.5 | 6.0 mm | R0.5 | 16 mm | 6.0 mm | 50 mm | 4 |
| CR65-D6-R1.0 | 6.0 mm | R1.0 | 16 mm | 6.0 mm | 50 mm | 4 |
| CR65-D8-R1.0 | 8.0 mm | R1.0 | 20 mm | 8.0 mm | 60 mm | 4 |
| CR65-D10-R2.0 | 10.0 mm | R2.0 | 25 mm | 10.0 mm | 75 mm | 4 |
| CR65-D12-R3.0 | 12.0 mm | R3.0 | 30 mm | 12.0 mm | 75 mm | 4 |
Radius tolerance +/-0.01 mm. Unequal flute spacing and long neck versions are available for deep shoulders.
| Workpiece / Operation | Recommended Series | Selection Reason |
|---|---|---|
| Hardened steel 45-65 HRC, finishing | 65 HRC Coated Series | Ultra fine grain carbide with AlTiN, holds the edge at high temperature |
| General steel and alloy steel milling | 60 HRC 4 Flute Square Mill | Balanced flute geometry for roughing and finishing in one tool |
| Stainless steel and soft sticky material | 66 HRC 4 Flute Series | Sharp positive rake and polished flute limits work hardening |
| 3D profile, curved surface, mold cavity | 2 Flute Ball Nose Mill | Ball radius generates the surface without scallop marks |
| Roughing with high removal rate | Wave Edge Roughing Mill | Wave edge segments the chip, lower radial force, less chatter |
| Corner radius, bull nose profile, R angle | 4 Flute Corner Radius Mill | R corner strengthens the edge and leaves a controlled fillet |
| Micro features 0.2-0.8 mm | Micro End Mill Series | Sub-micron carbide, 3 mm shank, high rigidity at small diameter |
| Aluminum and copper alloy, mirror finish | 3 Flute U Groove Aluminum Mill | Polished U groove and high helix evacuate soft chips |
![]()
![]()
![]()
Contact Us at Any Time