This 60 HRC solid carbide micro end mill series covers 0.2 mm to 0.8 mm in both flat and ball nose geometry with 2 flutes, on a 3.175 mm or 4 mm shank. At this diameter the shank does the work: the micro cutting tip is ground on the end of a full diameter shank, so the tool has the rigidity that a solid 0.3 mm shank cannot provide. The 0.2 um grain substrate holds a sharp edge at 0.2 mm, and the AlTiN coating limits wear when milling hardened steel electrodes, micro ribs and watch components. Flat tools cut slots and shoulders, ball nose tools generate 3D micro surfaces.
![]()
![]()
Example: ME60 - D0.4 x 1.2 x 50 - 2F - Flat - AlTiN
| Model | Cutting Dia. | Tip Type | Flute Length | Shank Dia. | Overall Length | Flutes |
|---|---|---|---|---|---|---|
| ME60-D0.2 | 0.2 mm | Flat / Ball | 0.6 mm | 3.175 mm | 50 mm | 2 |
| ME60-D0.3 | 0.3 mm | Flat / Ball | 0.9 mm | 3.175 mm | 50 mm | 2 |
| ME60-D0.4 | 0.4 mm | Flat / Ball | 1.2 mm | 3.175 mm | 50 mm | 2 |
| ME60-D0.5 | 0.5 mm | Flat / Ball | 1.5 mm | 3.175 mm | 50 mm | 2 |
| ME60-D0.6 | 0.6 mm | Flat / Ball | 1.8 mm | 3.175 mm | 50 mm | 2 |
| ME60-D0.8 | 0.8 mm | Flat / Ball | 2.4 mm | 4.0 mm | 50 mm | 2 |
Diameters from 0.1 mm are produced to order. Flat and ball nose tips are stocked in every listed diameter.
| Workpiece / Operation | Recommended Series | Selection Reason |
|---|---|---|
| Hardened steel 45-65 HRC, finishing | 65 HRC Coated Series | Ultra fine grain carbide with AlTiN, holds the edge at high temperature |
| General steel and alloy steel milling | 60 HRC 4 Flute Square Mill | Balanced flute geometry for roughing and finishing in one tool |
| Stainless steel and soft sticky material | 66 HRC 4 Flute Series | Sharp positive rake and polished flute limits work hardening |
| 3D profile, curved surface, mold cavity | 2 Flute Ball Nose Mill | Ball radius generates the surface without scallop marks |
| Roughing with high removal rate | Wave Edge Roughing Mill | Wave edge segments the chip, lower radial force, less chatter |
| Corner radius, bull nose profile, R angle | 4 Flute Corner Radius Mill | R corner strengthens the edge and leaves a controlled fillet |
| Micro features 0.2-0.8 mm | Micro End Mill Series | Sub-micron carbide, 3 mm shank, high rigidity at small diameter |
| Aluminum and copper alloy, mirror finish | 3 Flute U Groove Aluminum Mill | Polished U groove and high helix evacuate soft chips |
![]()
Contact Us at Any Time