The 6542 cobalt HSS spiral point tap is a straight flute machine tap made from M2 high speed steel with 5 percent cobalt, heat treated to HRC 62-65. The spiral point pushes chips forward through the hole, which makes it the correct choice for through hole tapping where chip evacuation must not depend on the operator. Cobalt HSS keeps the cutting edge hard at the temperature generated in stainless steel 304 / 316, where standard HSS taps lose the edge after a few dozen holes and start to gall. The straight flute body is rigid, so the tap holds the thread pitch even on a worn machine spindle, and the 6H tolerance class covers the majority of general purpose assembly threads.
![]()
![]()
Example: M8 x 1.25 HSS Co Spiral Point Tap 6H
| Size | Pitch | Thread Length | Shank Dia. | Overall Length | Flutes | Tolerance |
|---|---|---|---|---|---|---|
| M2 x 0.4 | 0.4 mm | 8 mm | 2.0 mm | 41 mm | 3 | 6H |
| M3 x 0.5 | 0.5 mm | 10 mm | 3.15 mm | 48 mm | 3 | 6H |
| M4 x 0.7 | 0.7 mm | 12 mm | 4.0 mm | 53 mm | 3 | 6H |
| M5 x 0.8 | 0.8 mm | 14 mm | 5.0 mm | 58 mm | 3 | 6H |
| M6 x 1.0 | 1.0 mm | 16 mm | 6.3 mm | 66 mm | 3 | 6H |
| M8 x 1.25 | 1.25 mm | 20 mm | 8.0 mm | 72 mm | 3 | 6H |
| M10 x 1.5 | 1.5 mm | 24 mm | 10.0 mm | 80 mm | 3 | 6H |
| M12 x 1.75 | 1.75 mm | 28 mm | 9.0 mm | 89 mm | 3 | 6H |
Spiral point taps are for through holes. For blind holes use the spiral flute version. Left hand, fine pitch and BSP threads are produced to order.
| Workpiece / Operation | Recommended Series | Selection Reason |
|---|---|---|
| Stainless steel internal thread M1-M12 | HSS Co Spiral Point Tap | 5% cobalt HSS resists work hardening and galling in 304 / 316 |
| Copper, brass and aluminium tapping | HSS Co Spiral Flute Tap | Polished flute lifts chips out of soft material without tearing |
| PCB, FR4 and copper clad micro holes 0.1-5 mm | Carbide PCB Drill Set | Sub-micron grain carbide with 3.175 mm standard shank |
| R angle, internal radius and edge profiling | Carbide Internal R Mill | Ground R profile, 2 flutes, coated for 55 HRC work |
| Roughing FR4 and abrasive laminate | Carbide Corn Cob Mill | Saw tooth edge removes laminate fast with low heat |
| Steel and stainless hand drilling 0.5-8 mm | HSS Co Twist Drill | 135 degree split point, no walking on curved surfaces |
| Chamfer 45 / 60 / 90 / 120 degree and spot drilling | Carbide Chamfer and Spot Drill | One tool spots the hole and breaks the edge |
| Hardened steel trimming up to HRC 65 | Carbide Chamfer Mill 65 HRC | Ultra fine grain substrate with AlTiN coating |
![]()
Contact Us at Any Time