This is a 3.175 mm shank solid carbide corn cob milling cutter for roughing FR4, copper clad board and other abrasive laminate. The saw tooth (corn cob) edge breaks the chip into small segments instead of producing a continuous ribbon: on glass fiber laminate this keeps the heat in the chip and away from the resin, so the cut edge does not smear and the tool does not build up. Because the edge is interrupted, the cutter also removes material with lower radial force than a standard 2 flute end mill, which allows faster feed on a light router gantry. It is used for board depaneling, slot milling, cut-outs and edge trimming before a finishing pass with a diamond cut router bit.
![]()
Example: CC-3175 - D2.0 x 12 x 38
| Model | Cutting Dia. | Cutting Length | Shank Dia. | Overall Length | Flutes | Coating |
|---|---|---|---|---|---|---|
| CC-3175-D1.0 | 1.0 mm | 6 mm | 3.175 mm | 38 mm | 2 | Polished |
| CC-3175-D1.5 | 1.5 mm | 8 mm | 3.175 mm | 38 mm | 2 | Polished |
| CC-3175-D2.0 | 2.0 mm | 12 mm | 3.175 mm | 38 mm | 2 | AlTiN |
| CC-3175-D3.0 | 3.0 mm | 15 mm | 3.175 mm | 38 mm | 2 | AlTiN |
| CC-3175-D4.0 | 4.0 mm | 18 mm | 3.175 mm | 45 mm | 2 | AlTiN |
| CC-3175-D6.0 | 6.0 mm | 20 mm | 3.175 mm | 50 mm | 2 | AlTiN |
Cutting diameter can be held to +/-0.01 mm for depaneling width control. Diamond cut finishing routers are available as a matched pair.
| Workpiece / Operation | Recommended Series | Selection Reason |
|---|---|---|
| Stainless steel internal thread M1-M12 | HSS Co Spiral Point Tap | 5% cobalt HSS resists work hardening and galling in 304 / 316 |
| Copper, brass and aluminium tapping | HSS Co Spiral Flute Tap | Polished flute lifts chips out of soft material without tearing |
| PCB, FR4 and copper clad micro holes 0.1-5 mm | Carbide PCB Drill Set | Sub-micron grain carbide with 3.175 mm standard shank |
| R angle, internal radius and edge profiling | Carbide Internal R Mill | Ground R profile, 2 flutes, coated for 55 HRC work |
| Roughing FR4 and abrasive laminate | Carbide Corn Cob Mill | Saw tooth edge removes laminate fast with low heat |
| Steel and stainless hand drilling 0.5-8 mm | HSS Co Twist Drill | 135 degree split point, no walking on curved surfaces |
| Chamfer 45 / 60 / 90 / 120 degree and spot drilling | Carbide Chamfer and Spot Drill | One tool spots the hole and breaks the edge |
| Hardened steel trimming up to HRC 65 | Carbide Chamfer Mill 65 HRC | Ultra fine grain substrate with AlTiN coating |
![]()
![]()
Contact Us at Any Time