This solid carbide micro twist drill bit uses a 4 mm (D4) shank with a reduced micro cutting diameter, a combination that solves a common production problem: the cutting edge must be 0.5-3 mm, but a 0.5 mm shank cannot be clamped rigidly in a standard collet. The D4 shank gives the collet full contact and the rigidity needed to drill stainless steel without chatter, while the carbide cutting tip and 140 degree point keep the hole on center. TiAlN or AlCrN coating limits built-up edge on stainless steel and titanium, and the polished flute lifts the chip out of a hole only a few diameters deep. Diameters are ground in 0.01 mm steps, so a specific fit or press fit hole can be matched without reaming.
![]()
Example: CBD4 - D1.20 x 4.0 x 50 - TiAlN
| Cutting Dia. | Shank Dia. | Overall Length | Flute Length | Point Angle | Tolerance |
|---|---|---|---|---|---|
| 0.50 - 1.00 mm | 4.0 mm | 50 mm | 4 - 8 mm | 140 deg | -0.005 mm |
| 1.01 - 1.50 mm | 4.0 mm | 50 mm | 8 - 12 mm | 140 deg | -0.005 mm |
| 1.51 - 2.00 mm | 4.0 mm | 50 mm | 12 - 16 mm | 140 deg | -0.008 mm |
| 2.01 - 2.50 mm | 4.0 mm | 60 mm | 16 - 20 mm | 140 deg | -0.008 mm |
| 2.51 - 3.00 mm | 4.0 mm | 60 mm | 20 - 24 mm | 140 deg | -0.01 mm |
Diameters ground in 0.01 mm steps. Step drills, coolant-through and left-hand versions are available on request.
| Workpiece / Operation | Recommended Series | Selection Reason |
|---|---|---|
| Stainless steel internal thread M1-M12 | HSS Co Spiral Point Tap | 5% cobalt HSS resists work hardening and galling in 304 / 316 |
| Copper, brass and aluminium tapping | HSS Co Spiral Flute Tap | Polished flute lifts chips out of soft material without tearing |
| PCB, FR4 and copper clad micro holes 0.1-5 mm | Carbide PCB Drill Set | Sub-micron grain carbide with 3.175 mm standard shank |
| R angle, internal radius and edge profiling | Carbide Internal R Mill | Ground R profile, 2 flutes, coated for 55 HRC work |
| Roughing FR4 and abrasive laminate | Carbide Corn Cob Mill | Saw tooth edge removes laminate fast with low heat |
| Steel and stainless hand drilling 0.5-8 mm | HSS Co Twist Drill | 135 degree split point, no walking on curved surfaces |
| Chamfer 45 / 60 / 90 / 120 degree and spot drilling | Carbide Chamfer and Spot Drill | One tool spots the hole and breaks the edge |
| Hardened steel trimming up to HRC 65 | Carbide Chamfer Mill 65 HRC | Ultra fine grain substrate with AlTiN coating |
Brand: Huaview | MOQ: 5 pieces | Stock delivery: 3-5 working days | OEM/ODM available (laser marking, custom coating, special diameter, length and shank). Send your workpiece material, hole diameter, thread size or profile drawing, and we confirm the correct model within 24 hours.
![]()
![]()
Contact Us at Any Time