This 55 degree solid carbide internal R milling cutter is ground from ultra fine grain tungsten carbide (0.4 um grain, HRC 55 substrate) and is designed for internal radius, R angle and reverse R profiling where a standard end mill cannot reach the corner. The 55 degree included angle matches the R angle chamfer called out on many mold, jig and fixture drawings, and the relieved neck lets the cutting edge follow an internal corner without the shank touching the wall. Two flute and four flute versions are available: two flutes clear chips in aluminum and soft steel, four flutes give a better surface finish in hardened steel. AlTiN coating raises the working temperature limit, so the same cutter runs on steel, stainless steel and aluminum without changing tools.
![]()
Example: R55 - D6 x R1.5 x 55 degree - 2F - AlTiN
| Model | Cutting Dia. | Radius | Included Angle | Shank Dia. | Overall Length | Flutes |
|---|---|---|---|---|---|---|
| R55-D4-R0.5 | 4.0 mm | R0.5 | 55 deg | 4.0 mm | 50 mm | 4 |
| R55-D6-R1.0 | 6.0 mm | R1.0 | 55 deg | 6.0 mm | 50 mm | 4 |
| R55-D6-R1.5 | 6.0 mm | R1.5 | 55 deg | 6.0 mm | 60 mm | 4 |
| R55-D8-R2.0 | 8.0 mm | R2.0 | 55 deg | 8.0 mm | 60 mm | 4 |
| R55-D10-R3.0 | 10.0 mm | R3.0 | 55 deg | 10.0 mm | 75 mm | 4 |
| R55-D12-R5.0 | 12.0 mm | R5.0 | 55 deg | 12.0 mm | 100 mm | 4 |
Radius tolerance +/-0.01 mm. Reverse R and asymmetric R profile cutters are made to drawing; send the profile sketch for quotation.
| Workpiece / Operation | Recommended Series | Selection Reason |
|---|---|---|
| Stainless steel internal thread M1-M12 | HSS Co Spiral Point Tap | 5% cobalt HSS resists work hardening and galling in 304 / 316 |
| Copper, brass and aluminium tapping | HSS Co Spiral Flute Tap | Polished flute lifts chips out of soft material without tearing |
| PCB, FR4 and copper clad micro holes 0.1-5 mm | Carbide PCB Drill Set | Sub-micron grain carbide with 3.175 mm standard shank |
| R angle, internal radius and edge profiling | Carbide Internal R Mill | Ground R profile, 2 flutes, coated for 55 HRC work |
| Roughing FR4 and abrasive laminate | Carbide Corn Cob Mill | Saw tooth edge removes laminate fast with low heat |
| Steel and stainless hand drilling 0.5-8 mm | HSS Co Twist Drill | 135 degree split point, no walking on curved surfaces |
| Chamfer 45 / 60 / 90 / 120 degree and spot drilling | Carbide Chamfer and Spot Drill | One tool spots the hole and breaks the edge |
| Hardened steel trimming up to HRC 65 | Carbide Chamfer Mill 65 HRC | Ultra fine grain substrate with AlTiN coating |
![]()
![]()
Contact Us at Any Time