This PCB solid carbide micro twist drill set covers the full micro hole range from 0.1 mm to 5.0 mm with a standard 3.175 mm (1/8 inch) shank, so the same collet holds every size in the case. The drills are ground from sub-micron grain tungsten carbide to HRA 92 with a 130 degree point: on FR4 and copper clad laminate this geometry cuts instead of pushing, which keeps hole position accurate and limits burr on the copper exit side. Each size sits in a labeled slot in an indexed case, so a machine operator can pick the exact diameter without opening loose bags. Sets are assembled to your size list, and single sizes are available in bulk for production lines that consume one diameter.
![]()
Example: PCB-D0.80 x 3.175 x 38 - 130 deg
| Diameter | Shank Dia. | Overall Length | Flute Length | Point Angle | Tolerance |
|---|---|---|---|---|---|
| 0.10 - 0.30 mm | 3.175 mm | 38 mm | 3.0 - 5.0 mm | 130 deg | -0.005 mm |
| 0.31 - 0.60 mm | 3.175 mm | 38 mm | 5.0 - 7.0 mm | 130 deg | -0.005 mm |
| 0.61 - 1.00 mm | 3.175 mm | 38 mm | 7.0 - 9.0 mm | 130 deg | -0.005 mm |
| 1.01 - 2.00 mm | 3.175 mm | 38 mm | 9.0 - 12.0 mm | 130 deg | -0.01 mm |
| 2.01 - 3.175 mm | 3.175 mm | 38 mm | 12.0 - 16.0 mm | 130 deg | -0.01 mm |
| 3.18 - 5.00 mm | 3.175 mm | 38 - 45 mm | 16.0 - 22.0 mm | 130 deg | -0.01 mm |
Standard set layout is 10, 20 or 50 pieces. Mixed diameter sets are assembled against your BOM; spare single sizes are packed in 10 piece tubes.
| Workpiece / Operation | Recommended Series | Selection Reason |
|---|---|---|
| Stainless steel internal thread M1-M12 | HSS Co Spiral Point Tap | 5% cobalt HSS resists work hardening and galling in 304 / 316 |
| Copper, brass and aluminium tapping | HSS Co Spiral Flute Tap | Polished flute lifts chips out of soft material without tearing |
| PCB, FR4 and copper clad micro holes 0.1-5 mm | Carbide PCB Drill Set | Sub-micron grain carbide with 3.175 mm standard shank |
| R angle, internal radius and edge profiling | Carbide Internal R Mill | Ground R profile, 2 flutes, coated for 55 HRC work |
| Roughing FR4 and abrasive laminate | Carbide Corn Cob Mill | Saw tooth edge removes laminate fast with low heat |
| Steel and stainless hand drilling 0.5-8 mm | HSS Co Twist Drill | 135 degree split point, no walking on curved surfaces |
| Chamfer 45 / 60 / 90 / 120 degree and spot drilling | Carbide Chamfer and Spot Drill | One tool spots the hole and breaks the edge |
| Hardened steel trimming up to HRC 65 | Carbide Chamfer Mill 65 HRC | Ultra fine grain substrate with AlTiN coating |
![]()
![]()
![]()
![]()
Contact Us at Any Time