This 65 HRC solid carbide ball nose end mill is a 2 flute R type cutter for 3D profile milling and mold cavity finishing in hardened steel up to HRC 65. The ball radius is ground on a 5-axis grinder and checked on an optical comparator, so the surface generated by adjacent passes matches without a visible scallop step. Two flutes give the chip room the ball geometry needs at the tip, where a 4 flute tool packs chips and breaks. The ultra fine grain substrate with AlTiN coating keeps the ball edge from chipping when it enters a hardened surface at an angle, which is the normal condition in cavity finishing.
![]()
Example: BN65 - D6 x R3.0 x 50 - 2F - AlTiN
| Model | Cutting Dia. | Radius | Flute Length | Shank Dia. | Overall Length | Flutes |
|---|---|---|---|---|---|---|
| BN65-D1-R0.5 | 1.0 mm | R0.5 | 2 mm | 4.0 mm | 50 mm | 2 |
| BN65-D2-R1.0 | 2.0 mm | R1.0 | 4 mm | 4.0 mm | 50 mm | 2 |
| BN65-D4-R2.0 | 4.0 mm | R2.0 | 8 mm | 4.0 mm | 50 mm | 2 |
| BN65-D6-R3.0 | 6.0 mm | R3.0 | 12 mm | 6.0 mm | 50 mm | 2 |
| BN65-D8-R4.0 | 8.0 mm | R4.0 | 16 mm | 8.0 mm | 60 mm | 2 |
| BN65-D12-R6.0 | 12.0 mm | R6.0 | 24 mm | 12.0 mm | 75 mm | 2 |
Long neck and long reach versions are available for deep cavities. Radius tolerance +/-0.005 mm, checked on an optical comparator.
| Workpiece / Operation | Recommended Series | Selection Reason |
|---|---|---|
| Hardened steel 45-65 HRC, finishing | 65 HRC Coated Series | Ultra fine grain carbide with AlTiN, holds the edge at high temperature |
| General steel and alloy steel milling | 60 HRC 4 Flute Square Mill | Balanced flute geometry for roughing and finishing in one tool |
| Stainless steel and soft sticky material | 66 HRC 4 Flute Series | Sharp positive rake and polished flute limits work hardening |
| 3D profile, curved surface, mold cavity | 2 Flute Ball Nose Mill | Ball radius generates the surface without scallop marks |
| Roughing with high removal rate | Wave Edge Roughing Mill | Wave edge segments the chip, lower radial force, less chatter |
| Corner radius, bull nose profile, R angle | 4 Flute Corner Radius Mill | R corner strengthens the edge and leaves a controlled fillet |
| Micro features 0.2-0.8 mm | Micro End Mill Series | Sub-micron carbide, 3 mm shank, high rigidity at small diameter |
| Aluminum and copper alloy, mirror finish | 3 Flute U Groove Aluminum Mill | Polished U groove and high helix evacuate soft chips |
![]()
![]()
Contact Us at Any Time